Avionics Bending: Mechanical Synchro Signal Producer (Part 4)

Mechanical Digital to Synchro Assembly

Here is the first design draft of the mechanical digital to synchro converter. The stepper motor on the bottom turns the Synchro Transmitter on the top of the design. The gear ration between the NEMA 17 motor and the Synchro should allow for very fine adjustment of the Synchro. The next rendering shows the the top plate and the Synchro Transmitter removed.

Mechanical Digital to Synchro Assembly

The picture below shows the assembly with the holder on the left hand side for the optical zero detection.

Mechanical Digital to Synchro Assembly

Another view of the prototype assembly from below. Here you can see the cutout for the NEMA 17 motor.

Mechanical Digital to Synchro Assembly

The entire assembly will be 3D printable. I will print the first prototype in PLA and then see how rigid the design is. The next step will be to add the design for the Beagle Bone Black holder and the 400Hz 26VAC  connections into the design.

Mechanical Digital to Synchro Assembly